7/4/2023 0 Comments Macloggerdx support![]() ![]() One issue remaining is that when I complete a QSO in WSJT-X (Sending a 73), the QSO is not automatically logged to MLDX via JT-Bridge, like it did in my previous setup with my old Elecraft K3. Clicking a CQ on the JT-Bridge log screen also opens the contact in MLDX, so that interface seems to be working ok. I was able to easily interface WSJT-X CAT control for the IC-7810 with no apparent issues.Īll CQs from WSJT-X properly appear on the JT-Bridge log screen.Īlso, I was able to set up JT-Bridge to properly interface with MLDX to verify stations that I had previously worked as well as confirmed (color coding). I installed WSJT-X 1.80, JT-Bridge 2.3.0, and MLDX 6.16, as well as the Silicon Labs drivers. I probably could have done a restore from my Time Machine backup, but didn’t want to also restore any issue that I had. Only real solution was to get a new drive and then do a clean install of MacOS High Sierra, as well as all my Mac application software. I had to disable the Fusion Drive Function, and in the process discovered that the hard drive portion of the Fusion Drive had numerous sector errors. It turns out I had an issue with the Fusion Drive on my Mac Mini, that prevented the Silicon Labs drivers from properly loading and then being recognized by my IC-7610. I finally resolved my issues after several phone calls to support at both Apple and Silicon Labs. I have also installed the following hamlib_settings.json file on my Mac per teh recommendation of the WSJT-X support team. I wonder if there are other settings tab need to be set. I am wondering if you or anyone else has been able to get these to work properly with the IC-7610.ĬI-V Address = 98h (Also tried address for 7300, 7600 andĬI-V USB/LAN – Remote Transceive Address = 00h I keep getting the following error message: Hamlib error: Communications bus error while getting current frequency I have been trying to get this combination of programs (WSJT-X, JT-Bridge and MacLoggerDX) to work with my IC-7610, but so far have been unable to get these to work. ![]()
0 Comments
Leave a Reply. |